Orthogonal Frequency Division Multiplexing (OFDM), Subcarriers, Resource Blocks and more in 4G and 5G

OFDM allows multiple subcarriers within resource blocks to overlap significantly while producing little to no interference, allowing 5G to use its frequency allocation far more effectively.

Orthogonal Frequency Division Multiplexing (more simply referred to as OFDM) allows multiple signals to overlap significantly while producing little to no interference. It supercedes Frequency Division Multiplexing (FDM), where signals do not overlap, and require a spacer (guard band) between them.


In 5G NR and 4G LTE, the individual signals that are multiplexed using OFDM are called subcarriers. These subcarriers act as individual channels which are used to transmit and receive data.

Each subcarrier is assigned a specific frequency within the LTE or 5G NR band. In LTE, subcarriers are always spaced 15 KHz apart. In 5G, the spacing is flexible (either 15 kHz, 30 kHz, 60 kHz, 120 kHz, 240 kHz, 480 kHz) to allow for a vast range of use cases.

Resource blocks (RBs)

⚠️ This section is written specifically about 4G LTE. These facts may not be completely accurate for 5G. Please perform your own research.

The number of subcarriers depends on the number of resource blocks (RBs) available, which itself depends upon the bandwidth available.

Every RB contains 12 subcarriers. This is fixed and never changes.

1.4 MHz672
3 MHz15180
5 MHz25375
10 MHz50600
15 MHz75975
20 MHz1001200


In LTE, each subcarrier can carry 15 thousand symbols per second (15 ksps).

A symbol is a unit of data consisting of one or more bits. The number of bits depends on how the symbol is encoded.

Encoding MethodBits per symbol
QPSK (4 QAM)2 bits per symbol
16 QAM4 bits per symbol
64 QAM6 bits per symbol
256 QAM8 bits per symbol
Max throughput calculation

20 MHz (1200 subcarriers) at 256 QAM

It's extremely important to note that you will never see speeds this high in real-world usage. Not only are your sharing access to the resource blocks with other users, but these calculations do not include any overhead that is present for coding and control purposes, etc.

OFDM in practice

As we mentioned earlier, OFDM is a technique that allows multiple signals to overlap significantly while producing little to no interference.

In 4G LTE and 5G NR, these signals are subcarriers inside each resource block.

Diagram of Orthogonal Frequency Division Multiplexing

Each signal is spaced apart so that the peak of any one signal lines up perfectly with the spectrum nulls of all other signals. You can see this by following the dotted lines in the diagram above from the peak down. This reduces the amount of interference from other subcarriers.


In 4G LTE, OFDM is only used for downlink from phone masts (eNodeB's) to your device (UE's). It is not used for uplink from the UE to the eNodeB.

For uplink, another frequency division method is used called Single Carrier Frequency-Division Multi Access (SC-FDMA). This is where the UE accesses the full bandwidth of a whole resource block for one or more symbol periods (the time it takes to send a symbol -- approx. 66.7 microseconds for LTE). This allows multiple devices to share access to the uplink frequencies, which being more power-efficient than OFDM.


In 5G NR, OFDM is used for both uplink and downlink.

Modern modems can transmit data much more efficiently then they could when 4G LTE was being finalised, meaning that OFDM can be used in both directions in modern devices.

Its specific form of OFDM is called CP-OFDM (cyclical prefix OFDM), which is what allows for the use of differing subcarrier spacing.